Replacement Steering Wheel Airbag Contact Reel (Clock Spring) 

To fit: Models without heated steering wheel

• S80II 2010-2016 from chassis number 113055 onwards

This part requires a specific fitting procedure and a basic overview of this process is below. If in any doubt whatsoever we recommend professional installation to be carried out for this product. It is just the contact reel only and does not include the angle sensor. 

*Note:  Using this new part requires the original carrier ring to be transferred over from the old part. 

 1, Centre the steering wheel straight ahead.

2, Disconnect the car battery and wait 30 minutes for the network to completely shut down, and in case of static discharge .

3, Remove airbag and old clock spring.

4, Install the new clock spring.

5, Remove the transport securing screw and turn the clockspring clockwise until you reach the stop.

6, Now turn the clockspring back counter-clockwise by the number of turns indicated on the yellow warning sticker on the new part.

7, Align the mark on the clock spring with the mark on the outer housing.

8, Reinstall the steering wheel and airbag.

9, Reconnect the car battery. 

If any stored fault codes still exist in the car's ecu then these would need to be cleared using VIDA or a similar workshop system. 

Important! Any part which suffers a broken contact tape failure resulting from incorrect positioning during fitting will not be covered by manufacturer warranty. 

Swedish supplied replacement aftermarket part.

Equivalent Volvo part number 31313818, 31313854, 31343218 Whole Part (for cross reference only)